Flywheel removal

[umeshg]

What do you use to remove Fly Wheel and where can I buy this device

There is a tool called Puller Bolts but I don;t know where I can buy it from

Thanks as ever

 

[cdewalt1985]

I just use 2 bolts turn them in till they both hit then slowly tighten each one 1/8 turn at a time and it pops right off

 

[renbar]

same here mate 2 bolts done job just be easy on the turns little on each then pop its free

 

[atom3624]

Whatever you do, don't lose the flywheel 'key'.
I nearly did when I took my flywheel off for the 1st time!!

Al.

 

[OuttaLuck]

I just use 2 bolts turn them in till they both hit then slowly tighten each one 1/8 turn at a time and it pops right off

+2 or you can buy the correct tool its like 15 bucks

Troy

http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4093/.f

 

[CAR-KILLER]

 

[umeshg]

+2 or you can buy the correct tool its like 15 bucks

Troy

http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.4093/.f

Thank you all for your feedback

 

[danielplace1962]

Get the proper tool. Those are incorrect methods of removal. A cross plate must be bolted to the flywheel and a center bolt pushes it off the center of the crankshaft.

There should be no force on the case and bearing.
Using the long bolt method all the force is going on the cases and the bearings inner race as it tries to pull the crank out of the engine till the flywheel comes off not a good idea at all. Good way to ruin the bearing.

 

[bhilly82]

I just take two pry bars and put slight pressure and have my wife lightly and I meen lightly on the loseend flywheel bolt. You will here a pop and it's off.

 

[Ian Bristol]

The proper tools are always the best bet, I removed a flywheel that was stuck fast and ended up damaging the housing because I used to much force.You can use many methods to do the job and most times you succeed. Do it right do it once.