Just noticed im leaking nitro between the heat sinc and the block.i was told it would be the head shim,so i have removed it and it doesn't look cracked or warped to me.it allstarted when i flipped the buggy and was running too lean on the day.by the time i got to buggy to switch it off,it was too hot.anyway,any suggestions?
Force. 32 head shim!
- Thread starter scott1
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Ildy666
Well-Known Member
Retorque it and c what happens...
rcspeedmart
Well-Known Member
When you flipped it you could have striped the head screws they are easy to strip I would try some new head screws and when you are tightening the heat sink back down make sure you tighten each screw a little at a time in an X pattern to make sure the heat sink goes down flat onto the head.