Sperera,who done the porting?
J.
J.
G260 Post Port Problems - Urgent
- Thread starter sperera
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
sperera
Well-Known Member
- Thread starter
- #22
local hobby shop, i can PM you details if you want but I don't want to post any names.
its started to cool off here around 8ish last night (had a top of 37degrees c) so I went down to the local footy ground to give it a bash and tune.
decided to take both needles back to 1.5 turns so I can learn how to tune these things (bout time I learnt anyway). couldnt get it to idle for a while, running very rich.
currently ls needle is just over 1.5 turns out and idle is nice. after about ten mins of running though the take off gets very boggy, long hesitation before it starts to move and pick up the revs.
what do we think, too lean or too rich?
its started to cool off here around 8ish last night (had a top of 37degrees c) so I went down to the local footy ground to give it a bash and tune.
decided to take both needles back to 1.5 turns so I can learn how to tune these things (bout time I learnt anyway). couldnt get it to idle for a while, running very rich.
currently ls needle is just over 1.5 turns out and idle is nice. after about ten mins of running though the take off gets very boggy, long hesitation before it starts to move and pick up the revs.
what do we think, too lean or too rich?
If its bogging mate its too rich,tighten the low speed needle an 1/8 th of a turn.
J.
J.