Right now I have the 16/48 on my stock 26cc MT and I want the gears that will get the highest top end. The 2 I found were the 20/42 but I just read where dwarfy said it should equal 64, so what 2 gears would I need? Also, would the Walbro 813 make any difference with the stock motor? Thanks.
Gear and carb question
- Thread starter New2FG
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Large Scale Alloy
Well-Known Member
You gear ratios go as follows:
16/48
18/46
20/44
18/42
The lower the spur gear the more top speed. Remember the more top speed the longer it will take for the truck to actually take off.
16/48
18/46
20/44
18/42
The lower the spur gear the more top speed. Remember the more top speed the longer it will take for the truck to actually take off.
atom3624
Well-Known Member
Some will say the Walbro 813 gives better pick-up from low revs with its 'accelerator', others say take care, as it can let dirt in, which you can seal ... I put one on my FG MT, without much experience with the standard so can't tell you other than it's mental anyway, and I LOVE IT !! :rockon:
Mind you don't gear too high and knacker your clutch.:badair:
Mind you don't gear too high and knacker your clutch.:badair: