has enyone had a ds1313 servo go up

[badd_maxx25]

i was running my buggy today and the brakes stopped working thought maybe the linkage came on done but it was the servo. It would only move to give it gas but not to the brake side

 

[mooman007uk]

Is that the stock servo? I threw mine in the garbage before I even fired up my MT

 

[badd_maxx25]

no i did the same thing it a ace servo

 

[badd_maxx25]

what would be a good servo to replace it with

 

[mooman007uk]

did you run it water...clubin just fryed his ace too

 

[badd_maxx25]

nope one of the guys who was running told me 2 of his freinds had the same thing happen. only thing i can think off is i sprayed some wd40 on the linkage maybe that got into it. but a few other guys did it to theres and and no problems with them

 

[IMADMAN]

Check your gears, if it only moves in 1 direction, than 1/2 of the gears are probably stripped.

 

[badd_maxx25]

it doesn't make a sound when i try to apply the the brakes idont think its the gears

 

[IMADMAN]

it doesn't make a sound when i try to apply the the brakes idont think its the gears[/quote
Did you check your EPA?


I'm putting a JR9000t in mine.

 

[RampageHopUps]

I use a Hitec 645MG in the Throttle/brake.

 

[badd_maxx25]

epa was set im just going to put a hitec hs5645mg in it

 

[ChopZilla]

Hey badd_maxx25 im the one who told you my friends did same thing we have the trucks lol I blew my two plastic gears after you left but the new motor ran great lol time to upgrade lol

 

[Clubin]

Yep, moisture will make a servo fail in that way, as stated above I just fryed a ACE 1015 I opened it up and there was condensation in the bottom. Mine would open the trhottle only and would not apply the breaks. On closer inspection, the circuit board failed die to the condensation.

 

[badd_maxx25]

i opened mine up no sign of water or dust the two ic board (the little black things 2 of the 4 were burnt up

 

[badd_maxx25]

test

 

[badd_maxx25]

how do i post pics