I am a bit worried about my low end needle and was wondering if any one could tell me how many quarters their low end needle is out.
My engine is a 29cc fuelie.
I just don't want to damage a new engine, it runs great and is just run in.
It has been used once after run in with some full throttle, but if i turn the low end needle any further back the car wont keep a continuous idle.
I've tried to turn it back and compensate with the idle screw, but the idle screw hasent got enough compensation, if you get my drifft.
My low end screw is at ten past and if i turn it fully in, it goes just between 2/3 and 3/4 to ten too.
I hope i'm making sence and sorry for any bad spelling.
My engine is a 29cc fuelie.
I just don't want to damage a new engine, it runs great and is just run in.
It has been used once after run in with some full throttle, but if i turn the low end needle any further back the car wont keep a continuous idle.
I've tried to turn it back and compensate with the idle screw, but the idle screw hasent got enough compensation, if you get my drifft.
My low end screw is at ten past and if i turn it fully in, it goes just between 2/3 and 3/4 to ten too.
I hope i'm making sence and sorry for any bad spelling.
Last edited: