help please

[cwgreen]

I slammed a curb today and when I started it up again it revs way high and the wheels are spinning. It also did this when I was breaking it in. It was idling and right before the tank was empty the wheels started spinning. Any ideas on this matter.

 

[GoffeeRedCat]

Reset your needle! When your tank is nearly empty it creates a lean condition and revs high and dies. Just like nitros

 

[BertR]

Goffee is right thats a lien one ..Turn both needles clock wise till they stop don't force them then back out Hsn 1.5 turns and lsn 1.25 give that a try and see what you get

 

[Guest]

I slammed a curb today and when I started it up again it revs way high and the wheels are spinning. It also did this when I was breaking it in. It was idling and right before the tank was empty the wheels started spinning. Any ideas on this matter.

If you had a hard impact you might have blown a gasket. If you have an air leak you will create a lean condition. It will run erratically and you won't get a good tune. If this is the case you can seize the engine. Look for any wetness where the head meats the case.