help!!

[GoffeeRedCat]

so i just got my killer bee!! and im about to install it!! where do i run the wire with the RFI blocker??? do i cut the engine shroud a liitle???

 

[Guantanamo Joe]

I drilled a little hole in the plastic part of the engine shroud... near the edge and then I cut out the sides so it was "C" shaped against the metal flywheel cover... does that make sense?

 

[GoffeeRedCat]

Yes it does but I don't have my drill!! I try to leave anything that reminds me of work at work lol

 

[cordy]

The two wires go to the stop switch on you engine then back to your radio box. I routed my wire down the roll cage to the radio box.

 

[Guantanamo Joe]

you can try cutting it with a saw or serrated knife... but it wont look as clean

 

[GoffeeRedCat]

Ok but from the switch where do I go??

 

[Guantanamo Joe]

which platform? MT? DUNERUNNER? XT?

 

[GoffeeRedCat]

I got an xt

 

[Guantanamo Joe]

Then go from the switch to the roll cage, down to your receiver/battery box. Make sure you zip tie it on the INSIDE of the roll cage and not on the outside. Once you get to the Batt box, run it in the same little notch the other wires go in and hook it up.

 

[Guest]

You can find an opening without cutting.

-

 

[Guest]

I trim all of the extra wire off. No need to have miles of wire stuffed in the batt box.

 

[GoffeeRedCat]

sweet!!! that where i ran it!!!

 

[Deluge1]

I ran mine through that space between the fan cover and the cylinder.