Hitec 5765 Doesn't Fit MT V3 Stock Steering Servo Mount

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
S

Shalako

Senior Member
Messages
120
Reaction score
0
Location
State College PA
So I upgraded my steering servo (5765) and throttle servo (5645) on my MT V3 and the 5765 doesn't fit the mount. The two holes on each side for the mounting screws are too close together. Any suggestions or do I need a different mount? Curious to know what you guys did with yours?


Thanks.


Sent from my iPad using Tapatalk HD
 
i have an xq 5040 servo for the steering. it's mounting holes are closer together as well like your hitec. i'm just gonna drill the mounting holes on the servo a lil bigger. woulda been nice if they woulda put extra holes in the mounting tab like they did on the other side lol.
 
Last edited by a moderator:
There is an aluminum mount with the correct holes. The easy way to take care of it is to just shave off the nub and drill two new holes. Very easy to do. No extra cost, just a little bit of time.
 
RCDAD said:
There is an aluminum mount with the correct holes. The easy way to take care of it is to just shave off the nub and drill two new holes. Very easy to do. No extra cost, just a little bit of time.
Click to expand...
RCDAD you have this in your store or a PN? Thanks again.

Sent from my iPad using Tapatalk HD
 
I just shaved the nubz off and drilled holes on all mine and there still holding up with less weight then aluminum
 
Well I removed the nubs and drilled new holes. I have the 5765 in the mount. Now it seems the splines on the servo where you attach the servo arm is smaller than the stock servo arms.

Thought it was no big deal but the supplied Hitec servo arm only has small holes for linkages, etc. I attached a pic and you can see the difference between the servo arms. I haven't researched yet but do they make servo arms that fit the 5765 that connect the same way as the stock ones?

It's just one thing after another. :) . Makes it interesting either way.

Sent from my iPad using Tapatalk HD
 
Back
Top