hitec 645mg

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
IAMTHETRAPP

IAMTHETRAPP

Active Member
Messages
38
Reaction score
0
ok guys i just attemted to install my new servo but when i turn on the remote and the car the servo wheel i guess damn near turns all the way around..wuts my prob redcats..its the throttle servo by the way
 
Last edited by a moderator:
ok guys did the centering an all but now when i squeeze the throttle nuthin but if i hit the reverse it works alil..plus it doesn't move the ummm the bar that goes to the engine from servo to make it accelerate..need more help
 
Does your servo horn fit on the servo? if it fits snug without forcing or putting the servo horn screw in it you should be fine. If it doesn't your servo horn may not fit/ is stripped. you may have to use one of the servo horns from the bag of servo horns you got with your servo. But first, like GoffeeRedCat said check your settings on your radio, and make sure your servo is centered which means it would be relatively quiet. It will make noise if it is trying to center or if you are turning it. good luck.
 
REVOlutionary Rampage said:
Does your servo horn fit on the servo? if it fits snug without forcing or putting the servo horn screw in it you should be fine. If it doesn't your servo horn may not fit/ is stripped. you may have to use one of the servo horns from the bag of servo horns you got with your servo. But first, like GoffeeRedCat said check your settings on your radio, and make sure your servo is centered which means it would be relatively quiet. It will make noise if it is trying to center or if you are turning it. good luck.
Click to expand...
The stock redcat horn will fit loosely. I had to use the one that came with the servo.
 
Back
Top