Hypercharger on XT

[Boostcreepr]

I recently purchased an RB Innovations Hyper Charger for my Redcat Rampage XT. I am having a slight clearance issue with my throttle servo and was wondering if there is a shredstack to angle the hyper charger up a tad to clear the servo. I shaved the servo mount already and don't want to take out anymore plastic and have durablity issues so im looking for a different approach.

 

[blak__jak]

here you go

http://www.davesmotors.com/af504

 

[Boostcreepr]

Re: Hypercharger on XT

That only works with the Baja filter, I need a flat surface to mount the hyper charger

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[Guest]

Would it clear if you ran both the throttle and brake linkages on the outside arm? You could then trim the other half of the servo arm off. I have seen some guys run this set-up for better air filter clearance.

 

[Boostcreepr]

Re: Hypercharger on XT

Yes it would, but I'm not sure how that would need to be setup to work properly..

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[Guest]

Here is an example. Not a very clear pic though.

-