I have a few Questions

[Slasher]

I just modded my right side steering servo mount and installed a hitec 805BB


servo but it is but it goes the same direction as the left side so i disconnected the left one but the new servo is not enough to steer correctly how do i reverse the 2 servo's so i can use both im using the stock 2.4 radio witch is 2ch


any ideas


my next question is


i just started my truck for the first time and broke it in by heat cycling it 5 times


and i noticed a few things


1-i noticed that i was blowing a little smoke out the ex oust upon acceleration


is that normal? it idles wonderfully but i noticed it was sluggish from a dead stop do i need the 8000 rpm clutch spring will that help


any help would be great thanks

 

[Obeast44]

Can you show me a pic of that 805 mounted? A little smoke out your exhaust is fine. If you are using the stock exhaust can and a stock clutch spring, it will be sluggish off the line. Especially an MT with those gargantuan wheels/tires. Get a DDM 7500 clutch spring, and a good tuned pipe and that will help ya out considerably

 

[Slasher]

Can you show me a pic of that 805 mounted? A little smoke out your exhaust is fine. If you are using the stock exhaust can and a stock clutch spring, it will be sluggish off the line. Especially an MT with those gargantuan wheels/tires. Get a DDM 7500 clutch spring, and a good tuned pipe and that will help ya out considerably [/quote

 

[Forist72]

I would not run it without a better TH servo unless you have a kill switch. It will save you big time if you get a better one.

 

[Forist72]

Nice job with the mount mod btw