Intake Manifold

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
So I do have the stock screws if you want em just pm me your address I don't have it anymore. The stock screws were too long for my need with my velocity stack and aluminum manifold.
 
Thanks I found them on ddm so I ordered a few with a dt1 haven't ordered a manifold yet two many ones I like lol

Sent from my Nexus 4 using Tapatalk 2
 
So I think the arm on my throttle servo is stripped and the ones that come with the 645 holes are to small would it hurt to drill them bigger

Sent from my Nexus 4 using Tapatalk 2
 
Not at all, thats what I had to do to mine. Your talking about the holes in the servo horn that the linkages go into right? Then thats fine. Just for your knowledge the racers edge aluminum servo horn for that servo the holes are the right thread for the throttle screw and the brake linkage fits great in the hole as well.
 
Motakitty said:
Not at all, thats what I had to do to mine. Your talking about the holes in the servo horn that the linkages go into right? Then thats fine. Just for your knowledge the racers edge aluminum servo horn for that servo the holes are the right thread for the throttle screw and the brake linkage fits great in the hole as well.
Click to expand...
I don't think racers edge aluminum servo horn came with the 645 servo, mine just came with a bunch of plastic ones with really small holes.
 
It didn't come with it. The racers edge one is an aftermarket part I was just letting you know about it since thats what I'm using right now
 
Back
Top