Intermittent Spark

[Mikeyost12]

I have not been able to get my Rampage MT, which I purchased less than a month ago, to run the last couple days. When pulling the cord, the motor does not even pop like it is trying to start. The spark plug was pulled and grounded to the engine block to check for spark. The first 3/4 pulls I did not see a spark, then after that, I started to get a little spark but not with every pull. The spark is very intermittent. I just need to know what your thoughts are on what is going on and what I should do to fix it?

 

[Dusty1]

Could be a faulty coil but holding to the engines block shouldn’t give you spark . It’s a cast aluminum block and head . Need to check off something actually metal . I just had to replace my coil ,it drooped out in the middle of stage 4 of break in and engine just died ... went through every thing imaginable from checking switch you name it I checked it then said screw it and just held hot end of spark plug in hand and gave it a couple good but slow pulls of the cord . NOTHING . Turned in a warranty to redcat on their site and had a new coil in hand a week later .

 

[Phill2]

Grounding

Could be a faulty coil but holding to the engines block shouldn’t give you spark . It’s a cast aluminum block and head . Need to check off something actually metal . I just had to replace my coil ,it drooped out in the middle of stage 4 of break in and engine just died ... went through every thing imaginable from checking switch you name it I checked it then said screw it and just held hot end of spark plug in hand and gave it a couple good but slow pulls of the cord . NOTHING . Turned in a warranty to redcat on their site and had a new coil in hand a week later .

Grounding on aluminium will work as it's a conductor.
Before you chuck the coil check the gap at the flywheel.
You should be able to slip a business card in there snugly.
It may have moved from vibration.