kill switch mounting locations

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Sharkey

Sharkey

Well-Known Member
Messages
778
Reaction score
0
Location
Abbotsford BC Canada
i just ordered a modified pico switch and am tossed up about were to put it on the car. for a nice clean install the ideal place would be in the receiver box, however im not sure i want to have kill switch wiring running that close to the receiver. im running an fm radio, not 2.4, hence why im a little unsure.

any thoughts???
 
Yo, I had the same problem when fitting my Battle switch, So I fitted it externally on a piece of Lexen so the led could be seen and covered the switch in Shoegoo to waterproof.
27112009062.webp
27112009061.webp
Matt.
 
Sharkey said:
i just ordered a modified pico switch and am tossed up about were to put it on the car. for a nice clean install the ideal place would be in the receiver box, however im not sure i want to have kill switch wiring running that close to the receiver. im running an fm radio, not 2.4, hence why im a little unsure.

any thoughts???
Click to expand...

hi mate i ran mine into the receiver box without any problems mate, i also run fm radio :cool2: will post some pics later :cool2:
 
You can use 2 radio box's...stack on top of each other....electronic stuff in 1 box
say on the bottom..top box for TX only.....I have so much electronic stuff for my new rebuild I need 3 radio box's....1 is just for the TX only......Just my opinion..Slawhammer
 
I shoe goo'd my kill switch on the semi to the fan shroud about a half inch from the coil. no problem. then I can see the light (it's an original pb killswitch). I just shoe goo'd the ends to water proof. the other 2 are new killer rc's with external lights so I mounted to the rx box lid
 
Back
Top