KM Baja 5b rear fender and chassis guard

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Thanks. Most of the work was to pattern the mounts around the hub carriers/bolt pattern and clear the arm ball joint. Hope yours turn out the way you plan.
 
Rubbermaid Takealongs 13 cup serving bowls product code 7A98. Stumbled on them at a local Meijer store. They had a ridge molded in that appeared to be a good match to cut along for the shape. The mounts are made from .064 aluminum sheet stock purchased from local hardware. Thanks.
 
Thanks. The chassis debris guards are made from 3mm foam rubber sheet purchased from local craft store. It is easy to work with and is quite tough. They are held in place with 3/8" wire clamps....same as used for the window kits. Easy to put on and remove and still get to the receiver box switch without removing the guard.
 
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks