Large engine mount

[stegy1]

Hi,guys.I found on e-Bay guy who sells alloy large engine mount for onroad cars.http://www.rc-car-online-shop.de/lshop,showdetail,28481,e,1281190061-31430,motor.motorbock.motormotorbockefg.1276856509,fg_7486,,Tshowrub--motor.motorbock.motormotorbockefg.1276856509,.htm

He says it can fit the marder, if i turn around the alloy engine clutch mount.
Will it fit on that way.

thanks

 

[frumpy]

I thought with the on road lg mount you have to use diff risers as well because the mount is taller for the onroads??

 

[pipeous]

you are right Frumpy. or you'd have to run spacers under the back side of the brace...

 

[stegy1]

Ok,i have diff risers so it will not be a problem.

 

[stegy1]

I just have thougt.If on road lg mount is taller,central shaft will not fit on alloy gear plate?

 

[pipeous]

it's just the part the brace bolts on is taller, the shaft hole is same location. the distance between the shaft bearing and top is longer on the on road mount. you will be good to go

see the tab on top is longer for the on road
http://www.rc-car-online-shop.de/ls...otorbock.motormotorbockefg.1276856458,,,,.htm

 

[frumpy]

Couldn't ya just put a spacer under that top plate then?

 

[Trebor]

Couldn't ya just put a spacer under that top plate then?

yep thats all you need to do



K....

 

[stegy1]

I got the engine mount,but he doesn't fit.Here is the pictures.Any proposition?

http://img217.imageshack.us/gal.php?g=p8240120.jpg

 

[pipeous]

you are going to have to dremmel a bit off the back motor case to allow the mount to move into position. it's the angle of the clutch housing as the on road motor is angled and it's the clutch housing is bolted onto the case a bit different.

 

[stegy1]

I dremmeled cluch housing and now mount can fit.But there is another problem.
Holes of the chasisis does not match to the holes of large mount so i have to drill another ones