Tobermory
Well-Known Member
Hi all,
my part for my shengqi have just arived:w00t: but as i ordered a fg layshaft i also had to get an fg breake square,however when i tried to fit the disk breaks over the brake square the hole in the disk is too small! so i was wondering if i would be better off cutting my brake disks to size(it would be quite tricky
) or would i be better off using my old layshaft and just screwing my layshaft gear onto it?? (btw it has no flat spots for the grub screws)
Thanks
Toby
Update* i will have to use the fg layshjaft as the standard shengqi one is too short for the layshaft gear to fit onto
my part for my shengqi have just arived:w00t: but as i ordered a fg layshaft i also had to get an fg breake square,however when i tried to fit the disk breaks over the brake square the hole in the disk is too small! so i was wondering if i would be better off cutting my brake disks to size(it would be quite tricky
) or would i be better off using my old layshaft and just screwing my layshaft gear onto it?? (btw it has no flat spots for the grub screws)Thanks
Toby
Update* i will have to use the fg layshjaft as the standard shengqi one is too short for the layshaft gear to fit onto
Last edited: