Lost a Wheel

[Trickle007]

Well it just fell off lol... where can i get the set pin,roll pin or what ever it is called for this?


I have the grub screw guess i did not lok tite the grub screw in or did not tighten it enough. Anyway any1 have a part# for me? or can i go and pick something up from the Home Depot perhaps?

 

[Obeast44]

Im pretty sure its a 4x22mm pin.

 

[lords]

you can try to match something up or grab it here

 

[KrashKrieg]

I cut up a bent 4mm hinge pin from my savage for you...fits perfect...I'll drop it off on my way into work...

 

[Trickle007]

You the man Krash thanks alot.

 

[pipeous]

old drill bits and a dremmel.

 

[Trickle007]

She is fixed time to tear it up after work..... thanks for all the replies

 

[lords]

sweet ...it's nice to have this forum and support...that makes me a happy mofo and it wasn't my issue...lol


thanks,krashkrieg for helping Trickle007 out mang...


I had to post as this made me a happy man on Friday

 

[Trickle007]

when i get a dremmel i am going to dremmel a flat spot on the pin and drive the grub screw right into the flat spot on the pin for a little added security so this don't happen again. I was so pissed when this happened cause i showed up to work an hour early to fine tune the settings on my new Futaba 3PM-x transmitter and with in 2 minutes the wheel fell of lol.


But it back up and running now so i will fine tune after work.

 

[pipeous]

and get some big shrink tubing to go over the pin and grub screw so they don't fall out if the loktite loosens