mt Blackwidow

[tedsterb]

i would like to know factory settings for mt 26cc on the carb what would the low needle be set at and the high needle be set

 

[Obeast44]

The high is 1 1/2 out and the low is 1 1/4 on most walbro carbs

 

[RampageHopUps]

That is a good starting point. Your X-can will breath a little different, so adjust it from there once it starts.

 

[lords]

Yep i would say 1 min fired up:30 sec's idle and 30 over half,


(depends on the clutch spring,foot holding the front wheels), and then adjust it for the X-can.


X-can is a totally nice setup.


It's the smallest rock hard performance in the 1/5th scale.


notice how most pipes look the same X-can don't and wheres the clone..lol


and still is unbelievable for what it can achieve.


hope you dial it in soon and make a vid...lol


P.S


TO ROB,


can we get just a post your track section?