My HSP Warrior SC

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
J

Johan

Well-Known Member
Messages
122
Reaction score
0
Location
Borlänge, Sweden
I've posted a few pics of my HSP previously but thought I'd create a new thread with pics and hopefully some updates as well :)


The HSP is a Redcat with some differences. It has the square drive with plastic gears, CVD's, single servo setup, vented clutchbell, V3 chassis. It came with the TT wheels and an ugly body.


Updates so far:


Walbro WT-990


Shread Industries Inclined ShreadStack


Z-RC Manifold - BLUE


Super Bee Gas Kill Switch


Python billet left engine mount


HPI air filter


DDM 9.5k rpm clutch kit installed in reverse direction


Craftwerks Plug Wire BLUE


GPM air filter cover


GPM pull start cover


DDM Dominator side pipe


Chili Racing belt drive (not fitted yet)


Extended 24mm hexes


Proline Desperado rear 5B rims and Rovan tires


FullForce RC high flow fuel line kit


Three hole tank grommet


Aluminum net on the crank case


UberRC bearing kit (not delivered yet)


Lipo's as RX pack: Zippy-K Flightmax 1600mah 2S1P 20C Lipoly. I haven't decided if I'm going to use them as singles or in parallel.


Castle Creations 10Amp BEC set to 6.6v


Steering servo: Turnigy S8166M Servo 154g / 33kg / .21sec


Gas/brake servo: HK15298 High Voltage Coreless Digital MG/BB Servo 66g / 15kg / 0.11s


This is what it looked like when I got it. Click on the pics for a larger image:


DSC_0068.webp


DSC_0069.webp


DSC_0070.webp
 
Last edited by a moderator:
Update time!

Rubber sealed bearings from UberRC mounted on a brand new gear plate. I got it for $5 from from someone who had switched to an aluminium one.



I had to mount the belt drive to see what it would look like:



Installation underway!



 


Aluminium tape added to the tank and the roll cage. Dunno if it'll do any good or not but I'm hoping it will deflect some of the heat.

 
Thanks guys! :D

There's a vent in the gas cap but it's too small so you end up with a vacuum lock in the tank. The result being the motor cutting out :)
 
Got some work done on the truck

I find the radiobox a bit cramped so I digged out an extra I had from a previous project. It's from a Traxxas Stampede IIRC.

Let the chopping begin:



Romved some material to get a snug fit:



Inside:



 






Plasti Dipped Castle 10A Bec. This is the inside.



The reason behind the Plasti Dip is to keep the electronics free from debris and dust more than waterproofing. Time will tell if it works.
 
Back
Top