my new 50 inch apache

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
im keen as to run it, ive waited around 6 weeks to get my hands on it, ill get some vidoe of it as soon as i can, ive used all the running gear from this boat

https://www.largescaleforums.com/showthread.php?t=6036

but this hull should be lighter and im not using the clutch, water pump and a few other things so it sould be around 2 kg lighter and since my bonzi was good for around 50 mph im hopping this one will be faster and ive brought some more props to test out :boat:

this boat has had the deep v stainless steel header cutom modified to shorten it, so i should get more power and top end revs out of the boat i hope or the pipe will be a flop, but i think it will imporve things :2guns:

the boat will be shipped from the other side of australia monday or tuesday, but since its christmass time and new years and all that jaz comming up the post an frieght companies will be flat out so im not expecting it for a couple of weeks atlest :no:
 
well ive been trying to buy some new and used props cheap to get ready for when the apache gets here ive been slowly trying to colect them over the last 2 months since this project started.

sofar ive brought a

Prather S275

Octura x470/2 (still in transit)

ABC 2814/3 Chopper

i still have a

Rmb 7016/3

Rmb 75mm 105mm 2 blade

Prop shop 6714/3

and im still on the hunt for

ABC 2714/3 Cleaver

prop shop 7015/2

i think with one for these 7 or 8 difrent props i should find a all round good one on the apache i would like for it to run around 50 mph
 
Back
Top