My new xb

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
9e9a5aju.jpg
ybudu7uz.jpg
 
I've completely gone through this and did redcat aluminum front and rear hubs, c hubs, center diff holder, gear plate, belt drive, cy 30.5 with esp ported head, rcmk hp crank shaft, zen coil, msd wire, 8k clutch, jetpro side pipe, aluminum intake manifold, walbro 990 carb, velocity stack, dt1 filter, killer rc kill switch and sss pull start cable, outerwears crank case and pull start cover, light weight flywheel, ngk spark plug, hitec hv servos, mt roll cage, wing removed. I use a hacked flysky gt3b
 
I kinda like the way they look but ya thats my next upgrade is the 7075 adapters and some baja wheels, maybe the front ones all the way around but not sure
 
Motakitty said:
I kinda like the way they look but ya thats my next upgrade is the 7075 adapters and some baja wheels, maybe the front ones all the way around but not sure
Click to expand...
Agreed. To bad the foams don't hold up. The tires aren't to bad. One plus is, they are really light.
 
Ya I want to keep the wheels light. I really liked the mt but its massive so thats why I made the cage fit my xb so I have the look I like but lightweight.
 
Does anyone know the dimensions on the baja tires like weight, height, width On the front and rear tires
 
I have some axial oversized bead lock wheels with some proline big joe 40 series tires that I might try to fit on. Only down side is that theyre 17mm hex but I have some hexes I can modify to see if I can mount them up. Theyre about the same height but alot wider
 
So happy, the motor I put together runs and runs well, fired up on 2nd pull even with the 990 carb. Very loud but now I just have to finish breaking it in. I ran almost a tank through it. My neighbors in my apartment complex didn't like it too much though
 
Back
Top