My RR EVO3 Project

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

vmlopes

Well-Known Member
Messages
68
Reaction score
0
Location
Reading, Berkshire
After having been out of the large scale scene for a while, thought I would give a 4wd a go after having been down the Baja route previously. Found a pretty ragged and rough looking MCD EVO3 sport on ebay an offer was made and a deal struck.

So a complete strip down, loads of new fastners, both diffs rebuilt.........various new rose joints and balls, new front and rear wishbones, new anti roll bars, new lower diff cases, hinge pins and lower braces, steel gears, V4 side pods and fuel tank...........Oddified red head 26cc 4 Bolt Zenoah, 813 Wallboro, TwinAir filter and velocity stack, Mielke exhaust, Killerbee, Spectrum rx & tx, Elcon wheels and KCR step pin tyres, Tygon fuel lines and winged filter

Couple of little bits to tidy the fuel lines and wiring, had a quick shakedown run today............goes like stink and handles like a go cart !!

Items on order...................Alloy Gear Carrier and Carbon Fiber Radio Tray
5550373807_e3ca8c68a6_z.webp
DSCN0465 by vmlopes, on Flickr

5550956320_b5368621f4_z.webp
DSCN0466 by vmlopes, on Flickr

5550956978_ba96644fb5_z.webp
DSCN0467 by vmlopes, on Flickr
5550375619_65c557abf8_z.webp
DSCN0468 by vmlopes, on Flickr

5550376141_c9b994a70d_z.webp
DSCN0469 by vmlopes, on Flickr

5550958920_d7e4a60bfc_z.webp
DSCN0470 by vmlopes, on Flickr
 
thats pucca mate....mine started like that about 2 years ago..this is a pic of about £1500 later.....check my album for more pics if u like and see the process...
 
Last edited:
Back
Top