Need Help Pls. Servos on new 5t getting stuck

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
N

no1skibum

Member
Messages
9
Reaction score
0
Location
Manchester, Vermont
G'day guys. Wondering if someone would be able to help me resolve my servo issues . Here is the problem. When steering (truck on or of ground) if i steer quick to the right the servo stops half way through its travel and vibrates, to the left no problem until i release the steering then the servo has trouble re-centering. If i steer slow all is OK. Throttle is the same, gas to fast and about 2/3 way the servo glitches and sticks there, brake same. But ease on the gas and it goes full travel no prob. Battery is stock and fully charged.:scared:
Here is what im running

Tx - Spektrum DX3s
Rx - Spektrum Sr300
Killer Bee V2s with Buzzer and light
Everything else stock

I was thinking its a power problem and that the receiver couldn't handle the servo draw, but the sr300 is rated from 3.5-9.6v and the servos are stock. I cant work it out. I would really appreciate any help guys, its killing me not being able to take out my truck.
 
If you still have the original radio....try it with that and see what happens....to rule out the servo's..

The speccy's have too many bloody settings...something could be out..
 
ya i was going to say check your tx/rx transmission speed. move it to the slowes settings (for analog servos).
 
Nice bit of info...the speky's get a bad review. Which in
my opinion is due to the ''cool factor" I have always had
pretty good luck with my DX3S.
So thanks for that bit of info...:clap:
 
Back
Top