Need help with carb install

[dropabomb]

Hi guys been a bit since I installed a new carb on a new motor but just got my motor back from OBr and wanted to install my carb. Anyway I can’t find a diagram or video anywhere showing the steps as showing an install. I think there’s a gasket between the carb the the billet intake but anything else? Can someone point me to a standard carb screw kit? I don’t have the long bolds and washers to attach it to the motor. It’s a zenith g340. Thanks for any direction

 

[evssv]

ditch the billet intake imo ?...
unless its working fine for u that is?...most on here had probs with this style ☹
U can order all the bits from ddm here?
http://www.davesmotors.com/G320RC-Parts-Diagram-.html
The 32-34 r the same ?aslong as u aint running a 34reed case that is?..
Then u'll needlonger carb bolts?

 

[crucialRC]

From 5:21 on may help you out

 

[dropabomb]

Thanks guys. Ditch the billet? Go with the brown plastic one? Can i ask why? Thanks so ouch for th help guys!!

 

[cbaker65]

Thanks guys. Ditch the billet? Go with the brown plastic one? Can i ask why? Thanks so ouch for th help guys!!

Aluminum will only transfer heat from the head to the carb. ,may damage the internals of the carb.!

 

[evssv]

And may give uneeded running isssues ?

 

[Z.hb71]

It goes like this, velocity stack or air filter base > gasket > carb > gasket > isolator/manifold> gasket > motor

 

[cbaker65]

A gasket between every thing that mats together ,an don't over tighten the screws ,or you will crack
the isolator!...

 

[Z.hb71]

Oh and make sure the gasket is the right way round, cuz there a tiny hole for the pulse, if you block that it won't run.