Need help with this bushing?

[rcnutctb]

Do any of you guys know were this may go Not even sure if it go's to a tt. Had the car a part and found this under my pit mat. Its a bushing that fits on the Diff drive pinion (part 50074) but not sure were it go's, if even on this car?Any help would be great .


Thanks Coleman. Here's the link can't down load pic to this site?


http://s1235.photobucket.com/albums/ff436/teedog12/

 

[Deluge1]

The only places on the MT/TT that use those kinds of bushings, are the steering rack or the brake cam. That I know of.

 

[Deluge1]

I would assume the steering rack, or the brake cam.

 

[rcnutctb]

I used a penny to give an idea of the size. Is it used as a spacer next to the brake pads?

 

[Deluge1]

Not that I know of. I just took a look at my MT, and there's really no other place it could go.

 

[rcnutctb]

Thanks Deluge

 

[Bill_G]

If it fits on the pinion, which is 10mm, then it would be too sloppy for the brake cam or steering. Also the brake cam bushings are flanged. If that's the center drive pinion I would guess it goes there in front of the bearing to shim it. My TT didn't have that, but I made one of similar thickness because it had a ton of play there.

 

[rcnutctb]

I ran the TT a couple times before I discovered the bushing under my pit mat. Without the bushing the play warped the gears a little.( I think) I did have it on the center drive pinion between the bearing and the head of the gear, everything was real tight. Not sure if I should go ahead and try to run it or not, and just buy new gears (center diff. gear and pinion gear)

Thanks Guys