need help!!

[badboy21]

i need to see actual pix of the wing mount mounted.i have the MT but im putting the wing mount i just don't know where and how its mounted.i cant figure out the manual hehe..thanks! couple of shots will be great.

 

[kryptonite5b]

ya. i'll get you a fe in a minute.

 

[badboy21]

thanks !


by the way anyone using killerbee switch#3 ??will it work with the rampage?

 

[kryptonite5b]

the killer bee will work wih the rampage. here is the wing mount set-up. you will have to remove the MT bumper. i installed the front bumper on the rear, but had to trim and use longer screws





/monthly_2009_09/583c605aa4161_wingmount001.jpg.2da04d3029e47d45b2a141c3d384d037.jpg

/monthly_2009_09/583c605aa5373_wingmount003.jpg.aeefdafc3f62aad342e9d89fcb53e196.jpg

 

[badboy21]

cool thanks ! without the front bumper u moved to the rear therell be nothing in there as a stock set up?

 

[kryptonite5b]

are you refering to the front bumper? i dremeled down an MT bumper and use that up front. you can still use the front bumper supports, but i don't. just longer hardare and nuts will keep the front bumper on. you can see my TTruggy bumper in these pics.





/monthly_2009_05/583c605aa65df_rageandtormentphotoshoot002.jpg.f1ae13d483b3ad2e94f441cad93734b3.jpg

/monthly_2009_09/583c605aa7a55_rageandtormentphotoshoot013.jpg.f1a77350077ce060094950e2241ead46.jpg

 

[RampageHopUps]

You can also buy the TT front bumper if you want it for looks.

 

[badboy21]

do u use the rollcage too or u eliminate the roll cage??

 

[DemonRC1]

I ran my TT Truggy conversion without a rollcage. I never busted a plug, however, I had an extreme roof landing and the plug punched a nasty dent in my roof. If I landed on anything other than that sand I would busted the plug and possible damaged the engine. I would keep the rollcage.

 

[kryptonite5b]

i run a cage. it doesn't do much besides support the body wich you will need, and protect the plug of course

 

[badboy21]

on the 1st and second screws ,what size are u using?and whats that tube running by the mounts??

 

[kryptonite5b]

on the 1st and second screws ,what size are u using?and whats that tube running by the mounts??

the clear tube is from the gas cap vent. my other 2 machines didnt need it but i couldnt get the tank to vent properly with out it. im not sure of the length on those two outside screws. just long enough to thread completly through the bumper and a few extra mm's into the wing mount

 

[badboy21]

ok got the wing mounted,do u have a pic of your body where it was cut ??thanks .