No more tire taping !

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

bigblkblazin

Well-Known Member
Messages
146
Reaction score
0
I figured I could get hpi tires but they are expensive and they ballon too much for my hv setup. FG tires are proven and they have wicked tire traction and the tire componds are excellent . I wanna leave work to put them on right now .


IMG_00000185.webp


IMG_00000183.webp


IMG_00000190.webp


IMG_00000186.webp
 
They fit perfectly on my rally . They are not a direct fit for the xbe unless you have 6mm and hexed sleeve nuts (not nutserts) which are 0.88 cents ... I have the 10 mm .. So either I will have to switch to the smaller stub axels or find 3/8 hex sleeve nuts .
 
They fit perfectly on my rally . They are not a direct fit for the xbe unless you have 6mm and hexed sleeve nuts (not nutserts) which are 0.88 cents ... I have the 10 mm .. So either I will have to switch to the smaller stub axels or find 3/8 hex sleeve nuts .
Click to expand...
I have been unable to locate m10 sleeve nuts as well. If you find any please share. :)
 
RCDAD said:
I have been unable to locate m10 sleeve nuts as well. If you find any please share. :)
Click to expand...
RCDAD , After a extensive search I have found there are no hex headed sleeve nuts that are 10mm .This is the best solution if you have 10mm axels is to cut the threads off and tap the stub axels to 6mm . 5mm is too small and will bend rather quickly. I didn't opt to use just the thread insteads because there is a perfect head on the bolt already . Also use a high tensil strength bolt . I will take pictures of what I did when I get home .
 
I should've had a video up by now ,But I don't wanna end up blowing this xl-2 before having a spare .
 
Back
Top