on Rampage XT, removing the flywheel cover.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
DEA

DEA

Member
Messages
8
Reaction score
2
Location
Louisville, KY
Do the screws through the chassis secure into the engine or in the cover only? I tried installing a kill switch and have stripped the heads. if the screws do not enter the engine, I could drill the heads and if I cannot remove them from the cover, replace the cover? Am I on the right path?
 
DEA said:
Do the screws through the chassis secure into the engine or in the cover only? I tried installing a kill switch and have stripped the heads. if the screws do not enter the engine, I could drill the heads and if I cannot remove them from the cover, replace the cover? Am I on the right path?
Click to expand...
You can drill the heads or retap them to standard threads because I have done this for some of my buddies rigs or if you don't have a tap use a small sheet metal screw in a pinch.
 
Dobber72 said:
You can drill the heads or retap them to standard threads because I have done this for some of my buddies rigs or if you don't have a tap use a small sheet metal screw in a pinch.
Click to expand...
Oh to answer your ? They do not go into the motor that far.
 
I to went to install a kill switch and rounded the hex out.how did you get yours removed and did they just thread into shroud?
 
When I have an Allen screw that is rounded if it isn't to bad you can use a torx bit to remove the bolt. If it is all you need to do is drill out the head of the bolt.
 
Back
Top