Parts that I mite need to have on hand

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
D

Drews Custom Arts

Member
Messages
42
Reaction score
1
I was just wondering, I bought the ( Redcat rampage MT version 3 )


If there are any parts that break or were out easy please let me no so I can order and have them on hand. I read abbout the stearing servos going on a lot of the trucks but mine has the dual servo setup. I was just wondering if this will be a problem down the road or if the dual setup works well and last. But if there any and I MEAN ANY other parts that break easy or were out please let me know. Thank you all for youre help.


P.S. I LOVR THIS SITE OR FORUM IT HAS BEEN A LOT OF HELP SO THANK YOU ALL VERY MUCH.
 
had one steering servo go out within the first 1/4 of a tank, changed it out with one hitec. the throttle/break servo is still holding up but im ready to change it too,(just in case). other than that everything else has been good (knock on wood LOL ) my motto is...

Bash it-Break it- Fix it!!
 
oldman1964 said:
had one steering servo go out within the first 1/4 of a tank, changed it out with one hitec. the throttle/break servo is still holding up but im ready to change it too,(just in case). other than that everything else has been good (knock on wood LOL ) my motto is... Bash it-Break it- Fix it!!
Click to expand...
I would highly recommend changing the throttle servo too, mine just went over this weekend and it go away from me and ended up burning up the clutch.
 
kill switch

That was one of the first things I bought. I am very familiar wen it comes to rc hobbies runing wild. I build completely, paint, and drive or fly rc vehicles for bout 12 to 15 years now. Although I have never had this scale before I have had about one race car two trucks and an airplane either just take off on me or get tottaly demolished because of no safty switch. It was a hard lesson to learn and expensive. So know that is the first thing I order wen I buy or order a new toy. But thank you for the advice it is greatly appreciated.
 
Redcat went to dual steering servos because the stock servo is week. You can run a single servo setup with a good quality servo.
 
Do u have a link that i could look at the servos with thanks

RCDAD said:
Redcat went to dual steering servos because the stock servo is week. You can run a single servo setup with a good quality servo.
Click to expand...
 
Drews said:
I like the dual settup but with two of them should I still be concerned or be ok for a bit
Click to expand...
My MT with dual steering only lasted a few tanks of gas. I have replaced them with dual hitec 755mg but I haven't run the truck yet to see how they perform. I think the 2 hitec servos were $74 shipped
 
Last edited by a moderator:
Back
Top