Phatdad Baja RTR 4.8mm front shock kit, does not FIT!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
R

roccos_van

Well-Known Member
Messages
191
Reaction score
0
I bought the phatdad front Baja RTR shaft kit (4.8mm) and I thought these were direct bolt in, after drilling the rampage shock bottom piece out so the rampage shock bottom piece would screw on the thread, I installed the rampage piston on with some washers and went to screw it together and I DOES NOT FIT! I can put it in and start to spin it but it won't catch and thread in.


Can anyowe help?


Thanks.
 
So what thread are you having the problem with? The shaft shock end piece or the piston nut? Or is it the main shock insert? I'm running that setup right now and didn't have problems. Mooman is too.
 
I can't seem to get the bottom main shock insert to screw in. I push it as hard as I can and spin in and it won't grab and thread in, which is very strange because everyone here is installing the baja parts and they seem to work well.


Thanks for your help so far.
 
Back
Top