Please help!!

[Guest]

They will have it also.

 

[Guest]

It us a side doninator for the mt. But on buggy and and its a one piece. Funny things is I only drove in parking lots so far

If the pipe is not lined up perfect it is always tugging on the head. I now do this to all my one piece pipes.

-

 

[maddmike]

Where can the silicone? Tubing where that at

 

[Guest]

Some automotive stores sell silicon radiator hose.

I get mine from here. http://www.siliconehose.com/commerce/ccc1032-4-ply-silicone-straight-hose--gloss-black-color.htm

 

[maddmike]

I will look into that maybe that as my problem. It be easier to take motor out then

 

[maddmike]

Rc dad is it the heater hose from. Hat site?

 

[maddmike]

Duh? I'm a dummie I didn't see silicone radiator hose---- my bad

 

[andyken]

If you are lucky, you can also get a sharp pointed punch and dimple it off center and tap it around

 

[papaw]

How was your luck getting stud out?

 

[Guest]

Rc dad is it the heater hose from. Hat site?

It is the silicon straight hose, right off the linked page.

 

[blak__jak]

if you have no luck with whatever you try and have no other choice I have a couple pull off stock heads' pistons and all I have no use for. pm me and i'll hook you up.

 

[maddmike]

I got a hole through the stud heated it up and put the ez outs in and I have had no luck so far. I have been thinking of just getting a new head from gizmomotors

 

[maddmike]

It is the silicon straight hose, right off the linked page.

Ok I got I found it thanks alot

 

[maddmike]

if you have no luck with whatever you try and have no other choice I have a couple pull off stock heads' pistons and all I have no use for. pm me and i'll hook you up.

Its a 29.5 head so I would have to change crank to use a stock head on it. Thanks a lot.

 

[maddmike]

I got stud out now I need to rethread. I want to try with the normal size and go up. I have never used a tap neither so I am going to have to figure this out

 

[blak__jak]

glad to here you got it. aluminum isn't to tuff to tap. good luck.

 

[maddmike]

Thanks hoping to get this rig on the road soon snow is almost gone