Raminator/80cc Taylor kill switch wiring help.

[Knx873]

Hi all. I just installed a Taylor 80cc in the truck. I have no idea how to wire the manual motor kill switch to the kill switch on the truck. There was one black wire from the stock motor that tied onto the bottom of the (red wire) on/off switch on the side of the truck. Any help would be greatly appreciated.
Thank you
Rick

 

[deathrawt]

I just ran a new wire spliced into the one wire on the Taylor engine and ran it to the toggle where the stock engine wire was

 

[Knx873]

I just ran a new wire spliced into the one wire on the Taylor engine and ran it to the toggle where the stock engine wire was

Thanks for the quick reply. Not sure what wire to attach it too.

 

[deathrawt]

I hooked that small red wire to the plug with the red wires that plug into the coil

 

[Knx873]

I hooked that small red wire to the plug with the red wires that plug into the coil

Ok thank you. Just to be clear that’s the closest red wire in the pic?

 

[deathrawt]

Yep that should work
My engine is the 50gt but it should be the same with the 80

 

[Knx873]

Thank you for your help

 

[deathrawt]

Before you soldier wires and make it permanent be sure to function check it first though

 

[Knx873]

Ok. I will thanks again.

 

[RickDizzle]

Thanks for the quick reply. Not sure what wire to attach it too.

Carbon frames....oooo...lala!
Any complete pics you can post. Have not seen one yet of the carbon frames on the Raminator.

 

[Knx873]

Lol. Only the two middle one’s. I was thinking it would be easier to cut and work with. I’ll post pics in a day or two. I’m working on it in my shop so it’s not at the house.

 

[RickDizzle]

Sounds good. Looks like some thick carbon!

 

[deathrawt]

Ughh, I tried not to notice the carbon frames on his truck
Last time I went to primals site to check out the carbon plates I spent 5k on a mega
Carbon bad ju ju lol