Rampage body strengthening?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
J

jacosj

Well-Known Member
Messages
347
Reaction score
0
Location
allendale, michigan
I was thinking about possible ways to strengthen a Rampage MT body....I have one coming from Rob next month and want ideas to make it more durable. I have some mesh drywall tape I will put on the inside of the body such as was recommended by someone on the forum. I also picked up a can of the spray in truck bed liner material. Was thinking of spraying it over the mesh drywall tape on the inside. Besides making the body heavier, thought it might protect it from heat damage a little bit since I will be using an X-can with about 3-4" stingers and don't want the body to warp. Any thoughts/experience on this?
 
I'd use tuck tape on the inside, It's super sticky. I'd then spray a thin layer of foam, but not the super expanding foam.....just the not so expanding foam.


I havn't tried this stuff yet but that's what's been rolling around in the back of my head
 
duct tape inside( esp under the body mount holes). and a piece of styro foam between the roll cage and the roof of the body. should stop a light roll from destroying it. take it off if your bashing.
 
What would fiberglass resin and that cloth stuff work like (the crap that bodyshop guys use on real cars) if you put a coating on the inside of a body after paint, do ya think the body would just break and crumble anyway and fall of the junk that ya put on the inside?
 
There's threads in other RC forums about using Fiberglass...If done correctly it will really reinforce the body well...
 
Back
Top