Rampage mt v3 t/b servo

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
H

Hardrock6788

Junior Member
Messages
3
Reaction score
0
Throttle servo does not work at all but if i install my steering servos in the throttle port on reciever it works the steering so i took servo for t/b apart and it smells if it has been very hot if servo is bad what should i replace it with on a low budget
 
A good budget friendly servo that I can recommend from a solid year of running it 3 times a week would be the Hitec 422. It's not a metal gear but who really needs it if your breaks and end points are set right. Any who its only 10-12 bucks.. Hope this helps you!
 
Thanks guys i really appreciate it and actually ran a ross a new hs-645 mg for 23 bux on ebay so hopefully that solves my problem if not will post more after i get the new servo installed
 
Grest to hear that i shouldnt have any issue but have found another issue with the front cv shaft its wore completely out and was trying to find a cheap route to fix it but all ive found so far is replacement axles in qty of 2 but just need one for my right front is there anyway of buying just a single axle because the end of the dog bone the pin goes thru is wollered out so a rebuild kit is outta the question
 
Back
Top