Rampage XBE motor mount options?

[Gigawatts2]

Any updates on the motor mount. I really need a couple.

 

[Gigawatts2]

I finished redesigning the old mount. It will save a lot in stock cost. I still have to re-do the upper brace to tie the two supports together.
I think I can get something to take a pic of this week.

I still need 2 that I can 56mm motor so let me know if you get them done enough to ship.

 

[Ol' fart]

I'm in the middle of a rush job so they will have to wait until the end of the week.

 

[James33]

Will your mount also fit a 5892 motor?

 

[Gigawatts2]

I was thinking the 5692 unless you think the 5892 is better for some reason

 

[James33]

My disclaimer, "I'm a rookie", just want to overbuild to keep temps down. Going to run a taller tire on my Chimera and I'm on grass fields most of the time. I just put together that ol'fart is 7075rc so I'm not sure you should follow my lead on anything haha.

 

[Ol' fart]

I know it will fit the 5692. Not too sure about the 5892. the Castle Creations motor fit so unless it's bigger than that it should fit. I have a six hole mounting pattern and a four hole pattern that covers every motor I have seen but.....I can modify one to whatever you have.

 

[Gigawatts2]

When are you shipping

 

[Gigawatts2]

I need 2 5692 mounts asap

 

[Ol' fart]

Ok, I'm open now. Starting the new E-motor mounts today.

 

[Ol' fart]

This is what I have so far. You'll have to use your axle. You get the oversized bearings,motor cam 6 or 4 mounting holes, 48 or 44 spur gear, 10-16 pinion gear. and the mount itself. I am still working on the upper brace. The Delrin and 7075 aluminum gears work well together but they do not work with steel gears. If you want to change to steel you will have to change them both. The old 41T gear will not fit. Cost is $100.00 plus shipping usually around $7.50
I have run four to test them and I'll sell those. how many of you want one so I can get an idea how many more to make ?

 

[James33]

I ended up buying a 2028 castle, as long as the set up will fit my Chimera, I'm good for one.

 

[Ol' fart]

Here's the pic

 

[Ol' fart]

It will fit the mount but it will hit the steering post. My chassis is a 1/2 inch longer to fit the 2028

 

[Gigawatts2]

I'll take it where do I pay

 

[Ol' fart]

I have to finish the upper brace. Then I will put it p on the website.

 

[Gigawatts2]

How's the brace coming

 

[Ol' fart]

Got it done, the new problem is gears. I don't have a good selection in stock. Please tell me now if you want one and what gears and motor cam you would like with it so I can make just enough,much faster that way. kit as shown is $100 plus shipping, don't send money now..

 

[Gigawatts2]

I need a 4 hole cam and the lowest gear you have that will work with a 5692 leopard motor

 

[Gigawatts2]

On 2nd thought give me both the 4 and 6 hole cam. Also a small and medium pinion with the bigger spur