Rear Axel Probs

[Gammo]

Hey guys just asking i have the dunerunner & my rear axel on the ends near the hubs there is a pin & gub screw that hold the pin in place....1 of the pins keeps come out i LT all the gub screws put keeps coming out (after about a days hard drive)......any of you guys had this prob.can any one help at all.....

 

[Deluge1]

Are you using red loctite? Allowing it to cure overnight before you run it? You could try to notch the pin so the set screw can dig in a little deeper.

 

[Gammo]

yes red....yes over night....mmmmmm a notch good idea..

I just love these forums.....i give that a try...thanks again..

 

[rcspeedmart]

Use red locktite let sit over night then use boots and grease that should hold them in alot better.