tizdaz
Well-Known Member
hi guys, rebuilding my 5T after a strip down and when trying to fit the shocks there seems to be quit a bit of angle to them facing inwards, is this normal!?
Spoke to mike at Taylor as im using the Taylor shock mounts and he said:
"Thats how the losi 5T was designed mate, identical to stock position, 100%, been critized in past and proved wrong with a angle check haha."
just seems like there is a lot of angle? And if i remove the spacer that goes through the eye of the shock then the cap of shock becomes to close to the mount and hits it?
Also i have the IRC center Diff Mount that i bought from Taylor, it has built in servo bracket which is good, but it means the stock radio tray wont fit!? any ideas, is there a specific radio tray thats meant to be used with the IRC center diff mount?
Any ideas? Cheers
Spoke to mike at Taylor as im using the Taylor shock mounts and he said:
"Thats how the losi 5T was designed mate, identical to stock position, 100%, been critized in past and proved wrong with a angle check haha."
just seems like there is a lot of angle? And if i remove the spacer that goes through the eye of the shock then the cap of shock becomes to close to the mount and hits it?
Also i have the IRC center Diff Mount that i bought from Taylor, it has built in servo bracket which is good, but it means the stock radio tray wont fit!? any ideas, is there a specific radio tray thats meant to be used with the IRC center diff mount?
Any ideas? Cheers
