vkumbo
Member
- Messages
- 10
- Location
- Bologna - ITALY
Hi all,
just wondering if anyone out there has tried to fit a reed engine on the leopard 4WD chassis.
I would like to buy a reed engine for my car but the bottom end of these kind of engines is full CNC. Shape is quite similar to the std Zenoah casting but not exactely the same so, since the standerd Zenoah is already very tight and precise in the car, I'm not so sure that the CNC bottom end will fit in the car.......did anyone already try??
I'm going to ask to the engine's manifacturer but if someone already tried to do it........
Thanks anyway for any reply or help regarding this topic!!
Bye
Umbo
just wondering if anyone out there has tried to fit a reed engine on the leopard 4WD chassis.
I would like to buy a reed engine for my car but the bottom end of these kind of engines is full CNC. Shape is quite similar to the std Zenoah casting but not exactely the same so, since the standerd Zenoah is already very tight and precise in the car, I'm not so sure that the CNC bottom end will fit in the car.......did anyone already try??
I'm going to ask to the engine's manifacturer but if someone already tried to do it........
Thanks anyway for any reply or help regarding this topic!!
Bye
Umbo