Servo 5745

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
island

island

Well-Known Member
Messages
144
Reaction score
0
Location
Guam USA
Any idea on how to install 5745 on the MT? The ball screw are to big for the blue servo horns that came with the 5745, do i drill the servo horn for it to fit? :rolleyes:
 
You Can But The Throw Will Be Too Short And It You Will Need 20 Feet To Turn Your Truck Around. Heres What I Did,i Took The BLUe Alu. Horns Ground Down One Side(rounded The Edge Incase A Rock Ever Got Jamed Under It). Then I Took My Stock Servo Horns And Snipped The Ends Off. Drilled Two Holes And Put Machine Screws Thru Them Both So They Are The Same Geometry As The Factory horns so The Truck Will Make A Sharp Turn.
 
Last edited by a moderator:
PISTOL PETE said:
You Can But The Throw Will Be Too Short And It You Will Need 20 Feet To Turn Your Truck Around. Heres What I Did,i Took The BLUe Alu. Horns Ground Down One Side(rounded The Edge Incase A Rock Ever Got Jamed Under It). The I Took My Stock Servo Horns And Snipped The Ends Off. Drilled Two Holes And Put Machine Screws Thru Them Both So They Are The Same Geometry As The Factory Steering And The Truck Will Make A Sharp Turn.[/QUOT
Pistol Pete can you by any chance send me some pics would really appreciate it, and thanks for the quick reply really wanna run already... :)
Click to expand...
 
Pistol Pete i got ya just kicked in, pics not needed sorry about that i only have 100MB in my brain had to delete some to stor new once inn!!! :D :D:D THANKSSS
 
Last edited by a moderator:
island said:
Pistol Pete i got ya just kicked in, pics not needed sorry about that i only have 100MB in my brain had to delete some to stor new once inn!!! :D :D:D THANKSSS
Click to expand...
heres a few hope this helps
 
Back
Top