servo horn ?/info
- Thread starter Tig
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
HiTec alloy or Multiplex polyurethane. cant show em' there under the cars.
J.
J.
charlieboy
Well-Known Member
i use hitech alloy seens good and strong 
Kamitiro Fan
Well-Known Member
All hitec alloy horns,they hold up well.
pipeous
Well-Known Member
whatever came with the servos, never broke one
Alloy or plastic Hitecs are the only ones that have held up for me.
Most of the time the platic wont snap but the center strips.
.
pipeous
Well-Known Member
I'd rather strip a servo horn than the little plastic gear in the bottom of a servo. much easier to replace
had all sorts if stripped plastic ones on my bajas.
went to hitec alloys and they didnt hold up, bent after a while.
then i found one i had from a plane. i think it was a MDT brand. was a dual long horn which i modded by cutting one end off. but it had a center brace so the horn arm was sahped like a cap T and it was very strong. they had them for Hitec, Futaba, JR, and Multiplex. but for my baja, i use the Rhino horn avail at DDM on my rhino equipped baja, and on the other is a hitec servo (soon to be rhino also) and teh MTD? brand horn.
went to hitec alloys and they didnt hold up, bent after a while.
then i found one i had from a plane. i think it was a MDT brand. was a dual long horn which i modded by cutting one end off. but it had a center brace so the horn arm was sahped like a cap T and it was very strong. they had them for Hitec, Futaba, JR, and Multiplex. but for my baja, i use the Rhino horn avail at DDM on my rhino equipped baja, and on the other is a hitec servo (soon to be rhino also) and teh MTD? brand horn.
Tim,are you sure you have been fitting the correct spline/horn together??They shouldnt strip.
J
J
Do the Rhino horns fit the Hitec's?
