Servo Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
I

ika

Well-Known Member
Messages
353
Reaction score
0
Hi,


My throttle servo failed on MT.


It moves only one direction, opened servo but no visible damage.


Did it happened to you?
 
What high voltage throttle servo you recommend?

Hitec servos are 6v only.
 
Bad servos happen to everyone. Look at the solder ont he circuit board. You will likely see a component that looks burnt and the solder melted. Once the solder melts, the component falls off or loses the circuit.
 
RampageHopUps said:
Bad servos happen to everyone. Look at the solder ont he circuit board. You will likely see a component that looks burnt and the solder melted. Once the solder melts, the component falls off or loses the circuit.
Click to expand...
Thanks , I will check.

Thinking to get high voltage analog servo, because low power consumption.

Any recommendation..
 
Back
Top