Servo Saver Shafts-mounts

  • Thread starter Thread starter ZielkeRacing
  • Start date Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Z

ZielkeRacing

Guest
Just waiting on some shafts that hold the steering linkage. Any ideas, its not offered from redcat..... it's the 2 shafts and the four bushings. I need one shaft and 2 bushings, until then i and out of commision.. :(
 
If you have an upgrade kit you can use the shafts from it on the rear , then you have two spares for the front. As for the bushings You may have to make your own......I searched high and low and couldn't find anything....
 
Thanks dude! I didnt think about that. I found one bearing in my bearing tray but need one more. Will need to measure it as I have no idea through the years what it even is ;) thanks again
 
mooman007uk said:
let us know the size of that bearing, i've been trying to find some small enough cos the stock bushes wear out quick....more sloppy parts:(...I've tried servo bearings I had knocking around...one was close but didn't get the banana
Click to expand...
I'd like a size as well, I think BC bearings is a place we could find what we need, or even ebay....
 
Just wanna run my truck, I will have to figure something out here soon its August in a few days. Its been over a month since I ran my truck. No steer - No turn ;)


i have an idea, going to lowes for a replacement on the bushings. Just growing impatient and want to drive my truck.
 
Last edited:
I have an idea for a quick fix, going to the hardware store this morning. Will let you guys know for anyone missing the bushings.
 
Back
Top