ok so i posted a video on here of my crash and messed my side dom pipe up i had got the pipe for free with the purchase of my TT roller so i had nothing to lose if i messed up with modding it, first what i did was measure the lenght of the one inch header section of the pipe it came to about 7 and a half inches i had to cut about 3 inches out of the pipe because of damage so i wanted to stay close to the original lenght of 71/2 inches for the header after cutting out the broken section of pipe i needed more lenght so i used my medium and large x-port with 3 copper exhaust gaskets, to make up for the losts lenght then I cut the remaining one inch section and re--welded it so it lined up purfect with the rest of the pipe i left it unwelded and added a silicone one inch heater hose and two clamps to keep the pressure off the header bolts if i crash (Iknow i will) haha also i only attached the pipe to the chassis with the front mounting bracket i left the rearmounting point not connected the pipe sits alittle higher and in a diffrent position than originally but i actually think it looks better, I took the rampage out front today to test it out and it seemed to performed better than when it was stock, so good I could almost get three wheels off the ground when i went into donuts, it does donuts faster than the Tasmanian devil!! haha i uploaded a few pics of the new pipe you might be able to see the little stinger tip is still alittle tweaked i need to get that straightened..
Last edited by a moderator:
