sky Silencer pipe kit

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Remove old pipe, be sure to remove all of the old gasket off the exhaust manifold. Install in this order:
Use the included two bolts and mount the small coupler flange and new gasket to engine. I assume you know the gasket sits between the coupler and exhaust manifold. You should use a torque wrench and torque it down to correct specs. Not sure what that magic number is.

Press rubber onto the coupler flange and use the adjustable clamp to tighten it down to the coupler.

Slide the other clamp loosely over the one you just installed, now insert the pipe into the rubber. Slide the loosely placed clamp over the rubber and the pipe and tighten.

Now attach the pin through the hole on the pipe and attach it to your chassis.

The key to this is to get your bolts equally tight and make sure their is no old gasket material left on the engine. You don't want an air leak. Hope this helps. I just saw a phot of this pipe on a baja. Don't remember where.......searching.
 
I have this pipe,check out this thread although the pictures are not very good


https://www.largescaleforums.com/showthread.php?t=14050


I have since turned it around so the stinger is coming out of the bottom,and be careful not to have it touching any of the plastic supports as it will melt them.
I would get you a better picture but its hibernating in the loft till the spring lol
 
thanks for the link. Though that pin...still kinda hard to tell where its fits onto the chassis.
 
Back
Top