slow action Servo?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
J

jerrdog

New Member
Messages
4
Reaction score
0
Hi i have a new Firehammer and with new batteries in controller and a fresh charge on the onboard battieries for the reciever and servo the steering is slow to the left and almost no righ turn at all, I adusted the trim on radio and no luck so I decided to uase the rubber end of a screw driver and tapped the top of servo and it worked fine. What do you think happened? Do i need a new servo already?

Thanks
 
Hi go back to your receiver its got to be that mucker your turning angel is most probably at say 50% its not the trim you need to set up you need to go to your steering setup
hope that helps you
 
If you tapped the top and the servo started working it sounds like a bad connection, have you checked all your wires, if so could be the servo has a bad joint inside. Does it have problems when not connected to the steering; just to be sure it's not being stalled by a stiff joint etc? :)
 
Back
Top