Stalling problem

[Boriqua935]

I put the order in for one. Will have by tues. How long is install? How difficult? What is involved

 

[Trickle007]

if you are still using the stock air filter pull out the air filter sponges and then remove the mesh screen. Now you can see 2 bolts remove those 2 bolts and the air filter assembly and carb all come off. It is real easy to do. Just make sure you order the gaskets for the carb as well.

 

[Boriqua935]

I did not order the gaskets. Hopefully lhs will have it

 

[Boriqua935]

I believe the problem has been resolved. I drill a bigger hole in gas cap, cleaned plug which was black and leaned out both L and high needles just a bit. I also adjusted the throttle srew. Ran almost a tank and she's is running sweet. Now that in have the 813 on order she will hopefully run even better. Thanks for everyones help. Like I said I'm new to gas, but learning fast with all your help.

 

[Boriqua935]

I believe the problem has been resolved. I drilled a bigger hole in gas cap, cleaned plug which was black and leaned out both L and H needles just a bit. I also adjusted the throttle srew. Ran almost a tank and she's is running sweet. Now that i have the 813 on order she will hopefully run even better. Thanks for everyones help. Like I said I'm new to gas, but learning fast with all your help.

 

[Trickle007]

I doubt lhs will have the gaskets you need but you might be able to find them at a local lawn mower shop that deals with weed wackers

 

[Boriqua935]

I may just use red gasket maker which is what I used for my baja pipes. Seals it up nice