start messed up motor wont start help again..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
R

rice4u

Member
Messages
18
Reaction score
0
i need help i installed everything and i don't know how to adjust the servo im reading the remote manual its confusing.. AND i tried starting my truck up and it wont start the pull start doesn't seem like its turning the engine over(really hard) i hope engine isnt seized, i removed the pull starter and it was pulling and retracking very well i don't know what else to do help.....
 
i guess we could use some more info.

what motor? what size, what pipe, what carb needle settings?

how did it run the last time it ran? did you make any recent changes.

sounds like you are having some remote setup issues as well. can you give us more info there as well? which servo T/B or Steering ect.....
 
rice4u said:
i need help i installed everything and i don't know how to adjust the servo im reading the remote manual its confusing.. AND i tried starting my truck up and it wont start the pull start doesn't seem like its turning the engine over(really hard) i hope engine isnt seized, i removed the pull starter and it was pulling and retracking very well i don't know what else to do help.....
Click to expand...

check the gap between your flywheel and coil, mine had moved and almost had the motor locked.
 
motor i don't know, size i don't know, pipe is a jetpro, carb needle don't know
i got the track as a gift, the last time it ran and started fine, i blew the throttle servo hitec hs5745 and i havnt touched it since. i got my new servo installed it and tried starting it and its very hard to pull like its stuck i took it apart and i was able to pull and it did retrack installed it back on and i still cant start it and im out of ideas...

Timmahh said:
i guess we could use some more info.

what motor? what size, what pipe, what carb needle settings?

how did it run the last time it ran? did you make any recent changes.

sounds like you are having some remote setup issues as well. can you give us more info there as well? which servo T/B or Steering ect.....
Click to expand...
 
how long did it set? was it new when you got it?

i would start with a new Plug, and reading thru the tuning tip i posted in this section of the forum.
 
Are you saying when you pull the pull start it will not turn the motor over?

You may have a rock stuck in the flywheel or the coil has fallen against the flywheel.

If its not either of the above, try removing the spark plug and see if it pulls over.

Get back to us.:)
 
i for sure will post what i find i'll start on it again tonight thanks guys!!

Bigger the Better said:
Are you saying when you pull the pull start it will not turn the motor over?

You may have a rock stuck in the flywheel or the coil has fallen against the flywheel.

If its not either of the above, try removing the spark plug and see if it pulls over.

Get back to us.:)
Click to expand...
 
Back
Top