start running

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
L

leduc alain

New Member
Messages
3
Reaction score
0
Location
montreal, quenec
good day for all. i am very new on this hobbies, and i have bought a used redcat rampage MT gas 26cc engine . when i start the engine, my rampage start run. can some some help me how to solve this problem. it is an engine tuning problem or it is something else. help needed.:o
 
Bonjour Alain et soyez bienvenu a LargeScale.
It sounds like you have a clutch problem.
With no engine running, can you roll it, thus spin the clutch bell? Does it bind? Does it make a noise?
I'm not familiar with these trucks, but they all initially use the same basic engine and clutch design before we all start changing things.
If the clutch is binding, check that the engine is mounted properly.
Check also that the clutch mount bearings are OK.
After this, it's time to remove the clutch bell from the clutch - not difficult - and you might find that the spring has stretched ..... quite a few options!

Al.
 
leduc alain said:
good day for all. i am very new on this hobbies, and i have bought a used redcat rampage MT gas 26cc engine . when i start the engine, my rampage start run. can some some help me how to solve this problem. it is an engine tuning problem or it is something else. help needed.:o
Click to expand...

They come with a 6000 rpm clutch. If your idle is too high it will want to take off.
 
thank you for trying to help me. i have a gas engine .
for Al. i ho not have a belt on my clutch , it is a box attached after my gas engine. and yes it i try to roll it with engine off, it makes a noise yes. but it did not have the problem when i bought it, and it was running great. it was winter, ad yo know the winter in Montreal it is ccold and since then i didn't make it run until this week.
it has 2 needles. HSP, and LSP.( high speed needle, and low speed nidle)
i will try to adjust those today.
but i have to thank you in any way
 
Back
Top